Unpacking the vending machine

SPECIFICATIONS

UNPACKING

NOTE: If the power supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified individual in order to avoid hazard.
The model and serial numbers
will be required in the event
that you need to obtain service
or parts for your snack machine. The numbers are on the
identification plate located on
the backside of the vending machine. Record the numbers on the space provided below. Refer to
these numbers on all
correspondence and inquiries
about this snack vendor.
Remove the "Knock-A-Way
support by placing a 2x6 under
the vending machine. Insert a large
screwdriver or prying tool into
the groove and split it in two.
Turn the leveling screws as far
as possible. See FIGURE 1.

Figure 1.

This snack vending machine was thoroughly inspected before leaving the factory and the delivering carrier has accepted this snack vendor as their responsibility. Note any damage or irregularities at the time of delivery and report them to the carrier. Request a written inspection report from the claims inspector to file any claim for damage. File the claim with the carrier (not the manufacturer) within 15 days after receipt of the machine.
Carefully remove the outside packing material so as not to damage the finish or exterior of the vending machine. Inspect the snack machine for concealed shipping damage. Report any damage hidden by the shipping material directly to the delivering carrier on a hidden damage report.

IMPORTANT INFORMATION - make sure you have model # and serial# of your snack vending machine.

MODEL NUMBER:
SERIAL NUMBER:

1-866-657-7549